DEOSAN D90 (20kg)
A detergent disinfectant powder for the circulation cleaning of all types of milking plants, especially those where milk meters are fitted
A combined detergent disinfect specially developed for the use in cleaning of all type of milking equipment by circulation.
Provides powerful bactericidal activity against thermoduric and psychotropic bacteria. D90 is suitable for use in both hard and soft water conditions, being of particular benefit in hard water and in water with a high iron content. Solutions of D90 penetrate milk residues rapidly and are extremely free rinsing. It is a white, water soluble granule powder, containing a blend of alkaline detergents with an organic chlorine release agent and caustic soda to improve detergency. D90 also contains a water softener and a rust control agent.
Approximately 160ppm available chlorine is released at the in-use concentration.
Key Properties
- Concentrated, less powder is required per wash.
- Powerful biocide & water softener, effective against a broad spectrum of bacteria.
- Water Softener & rust inhibitor, helps control rust and scale build up in milking plant.
- Versatile specially developed for cleaning all type of milking equipment by circulation.
- After each milking wash and brush off thoroughly any external soiling and hose down with clean water. Apply jetters to teat cups. Flush the system through with clean cold or warm water to remove all residual milk traces, running to waste.
- Run the required quantity of hot water(at approx.85°C) into the wash trough, adding Deosan D60 Powder at the rate of 150g/40L of water (6oz/10gal). Draw this solution into the plant until it discharges hot from the return line before allowing the solution to circulate. Aim to achieve an initial circulating water temperature of 77-82°C. Circulate for up to 10 minutes before running to waste. The temperature of the returning water should not be allowed to fall below 54°C during circulation.
- Thoroughly rinse the plant with clean cold water to which may be added Deosan Red Label Hypochlorite at a rate of 25ml to 40L (1fl.oz to 10 gallons) of water if required. Allow to drain thoroughly.
Monthly Inspection
The milking plant should be thoroughly inspected, paying particular attention to the condition of the rubber ware etc, replacing parts as necessary to ensure the plant is maintained in a good condition.
Descale Routine
A monthly descale routine should be carried out (at more frequent intervals if required), to avoid a build-up of scale and milkstone. Deosan Dilac Plus should be circulated at a rate of 9ml/L3/4 pint to 10 gallons) in warm or cold water.
